Home Contact us Terms & conditions Shopping cart


Linux SoM



This article is obsolete or related to an obsolete product.
Please contact us at info@acmesystems.it for any further information.

BEE Board Pinout

Bee is equipped with 4 wings (W1, W2, W3, W4) pin-like FoxG20 Daisy1.

Select the View:

Compared with Arduino Pinout

or Click Component on Bee Image
BeeBoard All Wings

All Wings

Pin W1 W2 W3 W4
1 3V3 3V3 3V3 3V3
2 TX AVCC MOSI Digital 11 Digital 8
3 RX AREF MISO Digital 12 Digital 7
4
GND SCK Digital 13 Digital 2
5
Analog 0 PWM Digital 10 Digital 3
6
Analog 1 PWM Digital 9 Digital 4
7 I2C SDA Analog 2 PWM Digital 5 I2C SDA
8 I2C SCL Analog 3 Digital 6 I2C SCL
9 5V 5V 5V 5V
10 GND GND GND GND
Arduino Compare All Wings

While remaining at a clock speed of 16Mhz, the logic signals of the Bee are at a level of 3.3V. This provides greater compatibility with modern chip and lower power consumption.

Hardware Reference




Acme Systems srl
Via Aldo Moro 53 - 00055 Ladispoli (RM) - Italy
P.IVA/C.F. 08114831004
Tel +39.06.99.12.187 - Fax +39.06.622.765.31
http://www.acmesystems.it -
Iscritta al Registro delle Imprese di Roma al n. 08114831004


Atmel© Certified Partner

Documentation Terms of Use
Acme Systems provides this documentation "as is" without warranty or guarantees of any kind. The mantainer of this site (Sergio Tanzilli), has gone to a great deal of effort into making this documentation as correct as possible. Acme Systems doesn't provide any direct support for the Open Source preinstalled software but provides, through these pages and forum posts, all the information required to obtain the sources, install, use and update the Open Source softwares runnable on the FOX Board, NetusG20, AriaG25 and Terra platforms. Please note that all the preinstalled softwares, used on the Acme Systems products, are Open Source and you will have to check the license terms provided (usually the GPL) by each author before using it in any commercial or non-commercial product, by yourself. Before sending emails or calling the Acme staff here are our contacts please note that WE ARE MAINLY HARDWARE DESIGNERS and NOT LINUX GURUS so could be better to post your questions directly to the forum listed below to be sure that all the contributors of this site and the large software developers community will read and reply to your questions.

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License.
Creative Commons License